Glass Grinder (Gryphette Diamond Grinder) ID:202: Difference between revisions

Jump to navigation Jump to search
no edit summary
(Creating new tool page on behalf of jeff.dumba)
 
No edit summary
 
(One intermediate revision by the same user not shown)
Line 19: Line 19:


==Usage==
==Usage==
TBD
 
# Place grinder in area with good ventilation and lighting.
# Add water to tray under the work surface.
## A notch is provided to drain excess water. Insure that water tray remains full of water during operation.
## Add water to water tray as required. Grinding without adequate water cooling the bit will drastically shorted the bit life.
# Place sponge in hole provided. Insure that bottom of sponge absorbs water from the tray.
## Insert sponge so that upper part of sponge touches the grinding bit.
## It is very important that the sponge keep the grinding bit wet during operation.
## New sponge strips may be cut from a standard kitchen sponge.
# Press glass, rock or tile to be ground against revolving grinding head with moderate pressure.
## Shape your material with smooth lateral strokes removing a small portion of the unwanted material with each pass.
## Do not apply excessive pressure.
# If you wish to drill a hole, use a grinding pin.
## Gently bring glass into contact with the top of the pin at a  45° angle until the hole is started.
## Rotate the material until it is flat on top of the grinding pin.
## Make sure that water is allowed to reach the contact point by directing water at the bit, or holding a wet sponge against the bit.
# When done, turn off the grinder. Clean grinder between uses. Rinse the sponge regularly.


==Troubleshooting==
==Troubleshooting==
Line 25: Line 41:


==Documentation==
==Documentation==
TBD
[https://data2.manualslib.com/pdf7/167/16682/1668140-gryphon/gryphette.pdf?6e1f7f76b72e08d55fee3cb1f3802df4 Manual]


==Links==
==Links==
TBD
TBD

Navigation menu