Glass Grinder (Gryphette Diamond Grinder) ID:202: Difference between revisions

Jump to navigation Jump to search
no edit summary
(Creating new tool page on behalf of jeff.dumba)
 
No edit summary
Line 19: Line 19:


==Usage==
==Usage==
TBD
 
# Place grinder in area with good ventilation and lighting.
# Add water to tray under the work surface.
## A notch is provided to drain excess water. Insure that water tray remains full of water during operation.
## Add water to water tray as required. Grinding without adequate water cooling the bit will drastically shorted the bit life.
# Place sponge in hole provided. Insure that bottom of sponge absorbs water from the tray.
## Insert sponge so that upper part of sponge touches the grinding bit.
## It is very important that the sponge keep the grinding bit wet during operation.
## New sponge strips may be cut from a standard kitchen sponge.
# Press glass, rock or tile to be ground against revolving grinding head with moderate pressure. Shape your material with smooth lateral strokes removing a small portion of the unwanted material with each pass. Do not apply excessive pressure
# If you wish to drill a hole, use a grinding pin.
## Gently bring glass into contact with the top of the pin at a  45° angle until the hole is started.
## Rotate the material until it is flat on top of the grinding pin.
## Make sure that water is allowed to reach the contact point by directing water at the bit, or holding a wet sponge against the bit.
# When done, turn off the grinder. Clean grinder between uses. Rinse the sponge regularly.


==Troubleshooting==
==Troubleshooting==
Line 25: Line 39:


==Documentation==
==Documentation==
TBD
[https://data2.manualslib.com/pdf7/167/16682/1668140-gryphon/gryphette.pdf?6e1f7f76b72e08d55fee3cb1f3802df4 Manual]


==Links==
==Links==
TBD
TBD

Navigation menu