351
edits
Table saw (SawStop) ID:172: Difference between revisions
Jump to navigation
Jump to search
fixed page
Craig.pearce (talk | contribs) (minor wording corrections) |
(fixed page) |
||
| Line 1: | Line 1: | ||
{{Equipment page | |||
| toolname = Table saw (SawStop) | |||
| model = | |||
| serial = | |||
| owner = Protospace | |||
| loanstatus = | |||
| arrived = | |||
| location = Wood shop | |||
| status = | |||
| permission = | |||
| certification = SawStop training required | |||
| photo = 172.jpg | |||
| caption = | |||
| id = 172 | |||
}} | |||
==Specs== | |||
10" SawStop table saw. Purchased used in 2023. | |||
Has technology that if you accidentally touch a moving saw blade, the blade is clamped down within about 3ms, reducing or hopefully avoiding serious personal injury. | |||
==Usage== | ==Usage== | ||
Size of blade is critical. | |||
Sawstop recommends a blade size of 10", plus or minus 1/16". A blade may be smaller than this this due to repeated sharpening's, and the clamping cartridge cannot be adjusted properly, and that will either take longer to clamp down in case of "triggering", not allow the saw to start, or if the blade is oversize, may cause immediate triggering, failure to start or maybe other problems. | |||
Accidentally triggering the safety feature will result in a cost of around $135 to replace the cartridge, and $80-120 to replace the blade, costs which will be the responsibility of the member. | Accidentally triggering the safety feature will result in a cost of around $135 to replace the cartridge, and $80-120 to replace the blade, costs which will be the responsibility of the member. | ||
| Line 33: | Line 35: | ||
==Documentation== | ==Documentation== | ||
TBD | |||