15
edits
3D printer, resin (Anycubic Photon 5.5) ID:159: Difference between revisions
Jump to navigation
Jump to search
m
3D printer, resin (Anycubic Photon 5.5) ID:159 (view source)
Revision as of 04:39, 23 February 2023
, 23 February 2023Fix headings
Parker.link (talk | contribs) (→Your First Print: Add end-of-print instructions) |
Parker.link (talk | contribs) m (Fix headings) |
||
| Line 16: | Line 16: | ||
This printer is an Anycubic Photon 5.5. Note that it has undergone an upgrade, making it more similar to the ELEGOO MARS 2 PRO (useful for slicing). | This printer is an Anycubic Photon 5.5. Note that it has undergone an upgrade, making it more similar to the ELEGOO MARS 2 PRO (useful for slicing). | ||
== Specs == | |||
Resolution/Build Size: | Resolution/Build Size: | ||
| Line 22: | Line 23: | ||
*Z: 160mm | *Z: 160mm | ||
== | ==Documentation== | ||
[https://www.anycubic.com/products/anycubic-photon-3d-printer Product Page] | [https://www.anycubic.com/products/anycubic-photon-3d-printer Product Page] | ||
| Line 28: | Line 29: | ||
[https://wiki.protospace.ca/images/6/60/NL-POT011-C_ANYCUBIC_Photon-english-20190906-V13.pdf Manual] | [https://wiki.protospace.ca/images/6/60/NL-POT011-C_ANYCUBIC_Photon-english-20190906-V13.pdf Manual] | ||
== | ==Usage== | ||
No training is required for this printer. Get someone to walk you through the process, and then you can print using it. | No training is required for this printer. Get someone to walk you through the process, and then you can print using it. | ||
| Line 52: | Line 53: | ||
#Start the print. | #Start the print. | ||
#Listen to ensure that 30 seconds after the print starts, you hear a popping noise as the print separates from the clear plastic sheet and stays attached to the blue build plate. Cancel the print if you don't hear the popping noise, probably. | #Listen to ensure that 30 seconds after the print starts, you hear a popping noise as the print separates from the clear plastic sheet and stays attached to the blue build plate. Cancel the print if you don't hear the popping noise, probably. | ||
#You can estimate the print time based on the Duration and Percent Complete. | #You can estimate the print time based on the Duration and Percent Complete. | ||
#When complete, use the [[Curing station (Anycubic Wash and Cure Machine) ID:160|Curing station]] guide/video to post-process, clean, and cure your print. | #When complete, use the [[Curing station (Anycubic Wash and Cure Machine) ID:160|Curing station]] guide/video to post-process, clean, and cure your print. | ||
#Drain the excess resin in the tray back into the bottle. Avoid contamination. Use a squeegee, and don't break the clear plastic sheet. | #Drain the excess resin in the tray back into the bottle. Avoid contamination. Use a squeegee, and don't break the clear plastic sheet. | ||