15
edits
3D printer, resin (Anycubic Photon 5.5) ID:159: Difference between revisions
Jump to navigation
Jump to search
3D printer, resin (Anycubic Photon 5.5) ID:159 (view source)
Revision as of 04:26, 23 February 2023
, 23 February 2023→Your First Print: Add end-of-print instructions
Parker.link (talk | contribs) m (→Your First Print: Add gloves to procedure) |
Parker.link (talk | contribs) (→Your First Print: Add end-of-print instructions) |
||
| Line 52: | Line 52: | ||
#Start the print. | #Start the print. | ||
#Listen to ensure that 30 seconds after the print starts, you hear a popping noise as the print separates from the clear plastic sheet and stays attached to the blue build plate. Cancel the print if you don't hear the popping noise, probably. | #Listen to ensure that 30 seconds after the print starts, you hear a popping noise as the print separates from the clear plastic sheet and stays attached to the blue build plate. Cancel the print if you don't hear the popping noise, probably. | ||
# | #You can estimate the print time based on the Duration and Percent Complete. | ||
#When complete, use the [[Curing station (Anycubic Wash and Cure Machine) ID:160|Curing station]] guide/video to post-process, clean, and cure your print. | |||
#Drain the excess resin in the tray back into the bottle. Avoid contamination. Use a squeegee, and don't break the clear plastic sheet. | |||
#Wipe down with IPA. | |||
==Discussion Threads== | ==Discussion Threads== | ||
[https://forum.protospace.ca/t/resin-printers-down/688 Resin Printers Down] | [https://forum.protospace.ca/t/resin-printers-down/688 Resin Printers Down] | ||