273
edits
Embroidery machine, CNC (Tajima TEJT II-C NEO 1501) ID:144: Difference between revisions
Jump to navigation
Jump to search
Embroidery machine, CNC (Tajima TEJT II-C NEO 1501) ID:144 (view source)
Revision as of 00:50, 11 October 2022
, 11 October 2022reorder
(unbold) |
(reorder) |
||
| Line 37: | Line 37: | ||
Supplies available at: [[Where to source tools and materials#Textiles]] | Supplies available at: [[Where to source tools and materials#Textiles]] | ||
===Bobbin=== | |||
L-type bobbin, takes 80wt thread, threads clockwise out under spring and through metal eyelet, leave 2" tail. Observe lubing requirements before reinserting. | |||
===Troubleshooting=== | |||
[https://forum.protospace.ca/t/troubleshooting-the-embroidery-machine-tip/2418 Machine detected a thread breakage] | |||
===Quick Start=== | ===Quick Start=== | ||
{{Warning|This "cheat sheet" is not a substitute for proper training and confidence in operating this very nice and expensive machine! If you're feeling unsure, ask for help!}} | {{Warning|This "cheat sheet" is not a substitute for proper training and confidence in operating this very nice and expensive machine! If you're feeling unsure, ask for help!}} | ||
| Line 57: | Line 62: | ||
#Adjust the speed slider to the slower 1/3rd | #Adjust the speed slider to the slower 1/3rd | ||
#Press "Start" | #Press "Start" | ||
===Rethreading A needle=== | |||
To cleaning cut a thread, put new thread under NO TENSION and cut at an angle. This makes the thread end a wedge and un-frayed which is far easier to thread through the eye of a needle | |||
Thread needle front to back (away from user), raise thread end up and into spring to hold it there. | |||
===Needle Replacement Procedure=== | ===Needle Replacement Procedure=== | ||
| Line 76: | Line 84: | ||
#Cut new thread and rethread the needle | #Cut new thread and rethread the needle | ||
<br /> | |||