273
edits
Embroidery machine, CNC (Tajima TEJT II-C NEO 1501) ID:144: Difference between revisions
Jump to navigation
Jump to search
Embroidery machine, CNC (Tajima TEJT II-C NEO 1501) ID:144 (view source)
Revision as of 00:48, 11 October 2022
, 11 October 2022unbold
(unbold) |
|||
| Line 30: | Line 30: | ||
*Weight 40 thread | *Weight 40 thread | ||
=== Materials === | ===Materials=== | ||
Bring your own backing. | Bring your own backing. | ||
| Line 60: | Line 60: | ||
# | # | ||
=== | ===Needle Replacement Procedure=== | ||
#Loosen Flathead screw, remove worn or damaged needle | #Loosen Flathead screw, remove worn or damaged needle | ||
| Line 81: | Line 81: | ||
Thread needle front to back (away from user), raise thread end up and into spring to hold it there. | Thread needle front to back (away from user), raise thread end up and into spring to hold it there. | ||
=== Bobbin === | ===Bobbin=== | ||
L-type bobbin, takes 80wt thread, threads clockwise out under spring and through metal eyelet, leave 2" tail. Observe lubing requirements before reinserting. | L-type bobbin, takes 80wt thread, threads clockwise out under spring and through metal eyelet, leave 2" tail. Observe lubing requirements before reinserting. | ||
=== | ===Troubleshooting=== | ||
[https://forum.protospace.ca/t/troubleshooting-the-embroidery-machine-tip/2418 Machine detected a thread breakage] | [https://forum.protospace.ca/t/troubleshooting-the-embroidery-machine-tip/2418 Machine detected a thread breakage] | ||