273
edits
Embroidery machine, CNC (Tajima TEJT II-C NEO 1501) ID:144: Difference between revisions
Jump to navigation
Jump to search
Embroidery machine, CNC (Tajima TEJT II-C NEO 1501) ID:144 (view source)
Revision as of 00:36, 11 October 2022
, 11 October 2022Quick Start guide added
No edit summary |
(Quick Start guide added) |
||
| Line 29: | Line 29: | ||
*Cost: $8500.00 | *Cost: $8500.00 | ||
*Weight 40 thread | *Weight 40 thread | ||
=== Quick Start === | |||
# Digitize your file - software magic process steps go here - and copy onto special USB 1.0 stick | |||
# Insert stick into USB port at rear left side of machine | |||
# Scan card on lockout device to power on Tajima | |||
# Choose your frame type at "Frame:" | |||
#* flat: the various flat circular green frames | |||
#* cap: the round metal hat torture device | |||
# "Initialize: On" allows the machine to home at calibrate, why would you ever turn this off? | |||
# Load your file from USB stick by pressing the "Data" button and scrolling through the list | |||
# "Color change:" | |||
#* uto if you'd like the machine to just run your color order | |||
#* manual: if you need to change fabrics or positions between colors/operations | |||
# Set your color change order, note this is in hexadecimal so 1-9 then 10 is typed using the "+10" button then 0 and shows up as A, so 11 is "+10" then 1 and will show up as B, etc. | |||
# | |||
==='''Needle Replacement Procedure'''=== | ==='''Needle Replacement Procedure'''=== | ||
| Line 51: | Line 67: | ||
Thread needle front to back (away from user), raise thread end up and into spring to hold it there. | Thread needle front to back (away from user), raise thread end up and into spring to hold it there. | ||
=== | ==='''Troubleshooting'''=== | ||
[https://forum.protospace.ca/t/troubleshooting-the-embroidery-machine-tip/2418 Machine detected a thread breakage] | [https://forum.protospace.ca/t/troubleshooting-the-embroidery-machine-tip/2418 Machine detected a thread breakage] | ||