23
edits
Lathe, miniature (Taig Microlathe II) ID:47: Difference between revisions
Jump to navigation
Jump to search
Lathe, miniature (Taig Microlathe II) ID:47 (view source)
Revision as of 22:24, 20 September 2014
, 20 September 2014no edit summary
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
|toolname=Miniature Lathe | |toolname= Miniature Lathe | ||
|model=Taig Microlathe II | |model= Taig Microlathe II | ||
|serial= | |serial= DUnn0 | ||
|owner=Edgar Yajure | |owner= Edgar Yajure | ||
|loanstatus=Long Term Loan | |loanstatus= Long Term Loan | ||
|arrived=Sep 16,2014 | |arrived=Sep 16,2014 | ||
|location=On | |location= On the shelf above the welding table | ||
|status=Working | |status= Working | ||
|permission=Use as you need it but try to not brake it | |permission= Use as you need it but try to not brake it | ||
|certification=Self-assessment of competence or ask Edgar. | |certification= Self-assessment of competence or ask Edgar. | ||
|itemphoto=[[File:Lathe4.JPG|right|]] | |itemphoto=[[File:Lathe4.JPG|right|]] | ||
| Line 31: | Line 31: | ||
Please note that this lathe does not have its own power switch which is why I lent it attached to its own power bar (Lazy). Please keep them together as one could inadvertently turn the rather spunky motor by plugging it in directly to the wall. | Please note that this lathe does not have its own power switch which is why I lent it attached to its own power bar (Lazy). Please keep them together as one could inadvertently turn the rather spunky motor by plugging it in directly to the wall. | ||
Last: Only engage pulley grooves that are in line with each other or else you will wear the belt right out in no time. When done, release the tension by picking both smallest pulleys so | The chuck key (a shorter 1/4 in rod) is currently AWL somewhere in my trunk but you can use the axial stop as long as you hold it close to the chuck, or else you will bend the rod. | ||
The little guy is capable of pretty decent precision but you need to take time, care and patience to true the tail stock as well as the jaws to the center of rotation. You can buy full blanks at LeeValley if you need to clamp something with minimum pressure. Please refrain from machining the existing aluminum jaws as they are the only jaws I have and you can't put the Al back on. | |||
Last: Only engage pulley grooves that are in line with each other or else you will wear the belt right out in no time. When done, release the tension by picking both smallest pulleys so the belt does not stretch | |||