Table saw (SawStop) ID:172: Difference between revisions
Eric.coyle (talk | contribs) m (→Contents) |
Craig.pearce (talk | contribs) (minor wording corrections) |
||
| Line 19: | Line 19: | ||
==Usage== | ==Usage== | ||
10" | 10" SawStop table saw. Purchased used in 2023. | ||
Has technology that if you accidentally touch a moving saw blade, the blade is clamped down within about 3ms, reducing or hopefully avoiding serious personal injury. | Has technology that if you accidentally touch a moving saw blade, the blade is clamped down within about 3ms, reducing or hopefully avoiding serious personal injury. | ||
Accidentally triggering the safety feature will result in a cost of around 135 | Accidentally triggering the safety feature will result in a cost of around $135 to replace the cartridge, and $80-120 to replace the blade, costs which will be the responsibility of the member. | ||
Requirements for using this are evolving, and as this is not your typical table saw, so you have to do your due diligence and read and understand how it operates. | |||
Wet lumber, metal particles, including staples can trigger it. So | Wet lumber, metal particles, including staples can trigger it. So members will have to take an upgrade certification to be able to use your card to operate it! | ||
==Troubleshooting== | ==Troubleshooting== | ||
| Line 42: | Line 42: | ||
Size of blade is critical. | Size of blade is critical. | ||
Sawstop recommends | Sawstop recommends a blade size of 10", plus or minus 1/16". A blade may be smaller than this this due to repeated sharpening's, and the clamping cartridge cannot be adjusted properly, and that will either take longer to clamp down in case of "triggering", not allow the saw to start, or if the blade is oversize, may cause immediate triggering, failure to start or maybe other problems. | ||
Revision as of 14:27, 3 June 2023
Sawstop table saw 10"
{Equipment page | toolname = Sawstop 10' tablesaw | model =?
| serial = ? | owner = protospace (2023) | arrived = | location = Woodworking | status = Working | permission =Certification required, cardlock installed | certification = woodworking1, with upgrade course | photo =img0465.jpg | caption = sawstop tablesaw | id = 172 }}
Contents
Specs
TBD
Usage
10" SawStop table saw. Purchased used in 2023.
Has technology that if you accidentally touch a moving saw blade, the blade is clamped down within about 3ms, reducing or hopefully avoiding serious personal injury.
Accidentally triggering the safety feature will result in a cost of around $135 to replace the cartridge, and $80-120 to replace the blade, costs which will be the responsibility of the member.
Requirements for using this are evolving, and as this is not your typical table saw, so you have to do your due diligence and read and understand how it operates.
Wet lumber, metal particles, including staples can trigger it. So members will have to take an upgrade certification to be able to use your card to operate it!
Troubleshooting
TBD
Documentation
Special Notes
Size of blade is critical.
Sawstop recommends a blade size of 10", plus or minus 1/16". A blade may be smaller than this this due to repeated sharpening's, and the clamping cartridge cannot be adjusted properly, and that will either take longer to clamp down in case of "triggering", not allow the saw to start, or if the blade is oversize, may cause immediate triggering, failure to start or maybe other problems.