Vacuum cart ID:134: Difference between revisions
Jump to navigation
Jump to search
m (updated image link) |
m (updated location) |
||
Line 1: | Line 1: | ||
{{Equipment page | {{Equipment page | ||
| toolname = Vacuum | | toolname = Vacuum cart | ||
| model = DIY | | model = DIY | ||
| serial = N/A | | serial = N/A | ||
| owner = Janet M | | owner = Janet M | ||
| loanstatus = Semi- | | loanstatus = Semi-permanent loan | ||
| arrived = 2014 | | arrived = Before 2014-10-29 | ||
| location = | | location = Laser cutter area | ||
| status = Working | | status = Working | ||
| permission = Open to Members | | permission = Open to Members | ||
| certification = Demo | | certification = Demo required | ||
| id = 134 | | id = 134 | ||
}} | }} | ||
==Usage | ==Usage notes== | ||
* Uses vacuum pump to create powerful vacuum, slowly. | * Uses vacuum pump to create powerful vacuum, slowly. |
Latest revision as of 18:21, 19 October 2019
Type | Vacuum cart |
Make/Model | DIY |
Serial number | N/A |
Original owner | Janet M |
Loan status | Semi-permanent loan |
Arrival date | Before 2014-10-29 |
Location | Laser cutter area |
Functional status | Working |
Usage permissions | Open to Members |
Certification | Demo required |
Wiki-ID | 134 |
Label | 1.0" 1.5" 2.0" |
Usage notes
- Uses vacuum pump to create powerful vacuum, slowly.
- Stores vacuum, optionally, in two 14" diameter storage tanks, takes several minutes to charge.
- Cart contains vacuum degassing chamber, to remove bubbles from fast setting epoxies
- Ball valves allow vacuum to be dumped from the storage tanks into the degassing chamber instantly.
- Has small vacuformer (6 inch x 8 inch)
- Plans for full size vacuum bed with infra-red bulb-based plastic heater above.
- Mates with 8' vacuum cannon accessory too.
- Doesn't like to run without resistance.
- There should be a minimum 5:1 ratio of liquid you are degassing to chamber size (the amount you're degassing is no more than 1/5 the size of the chamber).
- Try to avoid degassing anything that will boil under vacuum at 20 degrees Celsius (this includes water) as it will contaminate the oil in the vacuum pump. This is because we are not running a cold trap like a fancy laboratory.
- Other than that its pretty much mechanically self explanatory, the two large tanks are there so you can pre vac them out and use them to pull the chamber down quickly if you have a fast setting resin.