Table saw (SawStop) ID:172: Difference between revisions
Eric.coyle (talk | contribs) mNo edit summary |
Eric.coyle (talk | contribs) No edit summary |
||
| Line 30: | Line 30: | ||
==Special Notes== | ==Special Notes== | ||
Size of blade is critical. | |||
Sawstop recommends a blade size of 10", plus or minus 1/16". A blade may be smaller than this this due to repeated sharpenings, and the clamping cartridge cannot be adjsuted properly, and that will either take longer to clamp down in case of "triggering", , not allow the saw to start, or if the blade is oversize, may cause immediate triggering, failure to start or maybe other problems. | |||
Revision as of 23:07, 2 June 2023
Sawstop table saw 10"
{Equipment page | toolname = Sawstop 10' tablesaw | model =?
| serial = ? | owner = protospace (2023) | arrived = | location = Woodworking | status = Working | permission =Certification required, cardlock installed | certification = woodworking1, with upgrade course | photo =img0465.jpg | caption = sawstop tablesaw | id = 172 }}
Contents
Specs
TBD
Usage
TBD
Troubleshooting
TBD
Documentation
Special Notes
Size of blade is critical.
Sawstop recommends a blade size of 10", plus or minus 1/16". A blade may be smaller than this this due to repeated sharpenings, and the clamping cartridge cannot be adjsuted properly, and that will either take longer to clamp down in case of "triggering", , not allow the saw to start, or if the blade is oversize, may cause immediate triggering, failure to start or maybe other problems.