378
edits
Laser Cutter, Thunder Nova 51 ID:178: Difference between revisions
Jump to navigation
Jump to search
→Troubleshooting
| Line 168: | Line 168: | ||
==Troubleshooting== | ==Troubleshooting== | ||
==== Indicate light ==== | |||
* If laser machine is running a job or user starts it without closing door or water protection, the signal lamp is in red light. The red light indicates the dangerous situation and user must stay with the laser. | * If laser machine is running a job or user starts it without closing door or water protection, the signal lamp is in red light. The red light indicates the dangerous situation and user must stay with the laser. | ||
* If laser machine is not at work, the signal lamp is in green light. The green light indicates the safety situation and the laser machine is ready for operation. | * If laser machine is not at work, the signal lamp is in green light. The green light indicates the safety situation and the laser machine is ready for operation. | ||
* If temperature is higher than 55°C/131°F on working table, the signal lamp will make buzzing sound.(roughly 80dBA within 1m,75dBA within 5m and 65dBA within 10m,the sound gets weaker as it travels). | * If temperature is higher than 55°C/131°F on working table, the signal lamp will make buzzing sound.(roughly 80dBA within 1m,75dBA within 5m and 65dBA within 10m,the sound gets weaker as it travels). | ||
==== Chiller ==== | |||
The chiller alarm status connected to the Thunder laser. But it isn't really "interlocked" as it only sends a problem signal if there is a power interruption or an active alarm. | The chiller alarm status connected to the Thunder laser. But it isn't really "interlocked" as it only sends a problem signal if there is a power interruption or an active alarm. | ||
| Line 180: | Line 180: | ||
The Thunder simply assumes the chiller is operating normally unless it is told otherwise. If any part of the alarm signal path is disconnected or broken, the Thunder will not be aware of problems with the chiller.[https://support.thunderlaserusa.com/portal/en/kb/articles/chiller-alarm-signal-and-cable-troubleshooting-guide-for-water-protect-error-2-8-2022#2_Check_Wiring_at_the_machine_socket] | The Thunder simply assumes the chiller is operating normally unless it is told otherwise. If any part of the alarm signal path is disconnected or broken, the Thunder will not be aware of problems with the chiller.[https://support.thunderlaserusa.com/portal/en/kb/articles/chiller-alarm-signal-and-cable-troubleshooting-guide-for-water-protect-error-2-8-2022#2_Check_Wiring_at_the_machine_socket] | ||
==== Connection ==== | |||
Lightburn is showing disconnected, save your project and restart. Lightburn device should now show as ready. | Lightburn is showing disconnected, save your project and restart. Lightburn device should now show as ready. | ||
==== Bed Not Level ==== | |||
If the bed appears to be out of level, verify that the hexagon bed is seated properly. There are 4 holes for the pegs on the bed to sit in. | If the bed appears to be out of level, verify that the hexagon bed is seated properly. There are 4 holes for the pegs on the bed to sit in. | ||