Laser Cutter, Thunder Nova 51 ID:178: Difference between revisions

Jump to navigation Jump to search

Laser Cutter, Thunder Nova 51 ID:178 (view source)

Revision as of 15:28, 31 March 2024

513 bytes removed ,  31 March
Removed non applicable info and added link to auto focus calibration
m (updated locaiton)
(Removed non applicable info and added link to auto focus calibration)
Line 101: Line 101:


*[[/www.thunderlaser.com/video/how-to-use-auto-focus/|How to use laser autofocus - THUNDER LASER]]
*[[/www.thunderlaser.com/video/how-to-use-auto-focus/|How to use laser autofocus - THUNDER LASER]]
=== Calibrating the Auto-Focus ===
* [https://www.youtube.com/watch?v=DHtElZjkgRc Calibrating the laser autofocus - THUNDER LASER]


===Setting Focus Height===
===Setting Focus Height===
Line 119: Line 123:
The Air-assist control is an additional tool for laser machines.Generally, cutting needs the air assist with high air-volume but engraving needs the air assist with low air-volume. Air-assist control is available in high- and low-volume for engraving and cutting-jobs via software-setting, this will increase the ease of use of your laser machine.
The Air-assist control is an additional tool for laser machines.Generally, cutting needs the air assist with high air-volume but engraving needs the air assist with low air-volume. Air-assist control is available in high- and low-volume for engraving and cutting-jobs via software-setting, this will increase the ease of use of your laser machine.


1） How to select the air assist with high volume or low volume? In RDworks software, high volume or low volume is selected on the “Air-Assist Control” option. We suggest select “High” for cut mode and select “Low” for scan mode(engraving mode). You can also set default for “Air-Assist Control” option, so in cut mode, it will select High volume automatically, and in scan mode (engraving mode), it will select Low volume automatically. How to set default for “Air-Assist Control” option? Go into the RDworks’s root directory>>open the text file of “soft”>>change the setting of “ShowBlow”>>save the text file, like below.
1） Need image of Lightburn air assist switch. Previous source here was for software we don't use and therefore not applicable to our machine.
[[File:Screen cap of layer Parameter screen in Lightburn.png|center|thumb|576x576px|Screen cap of layer Parameter screen in Lightburn]]
 
2) How to adjust air volume if require? For High volume mode, 1. Make sure machine is not at work and laser switch is off 2. Click the left green button to start the air-assist with high volume 3. Check the air volume under the laser head 4. On left flow control valve, loose the locked nut then rotate the adjusting screw to control the air volume to mean your requirements. 5. Fix the locked nut after finished. And for Low volume mode, you do it the same
2) How to adjust air volume if require? For High volume mode, 1. Make sure machine is not at work and laser switch is off 2. Click the left green button to start the air-assist with high volume 3. Check the air volume under the laser head 4. On left flow control valve, loose the locked nut then rotate the adjusting screw to control the air volume to mean your requirements. 5. Fix the locked nut after finished. And for Low volume mode, you do it the same
[[File:Air-assist Control nova manual page 56.png|center|thumb|Air-Assist Control panel, taken from Thunder laser nova series manual page 56]]
[[File:Air-assist Control nova manual page 56.png|center|thumb|Air-Assist Control panel, taken from Thunder laser nova series manual page 56]]
Craig.pearce
24

edits

Retrieved from "https://wiki.protospace.ca/Special:MobileDiff/6764"

Navigation menu