Laser cutter (Trotec Speedy 300) ID:107: Difference between revisions

Laser cutter (Trotec Speedy 300) ID:107 (view source)

136 bytes added , 17 January

1

edit

@@ Line 104: / Line 104: @@
 ======JobControl says that "job will not fit on plate"======
-When printing, venture into the Trotec Engraver printer settings and ensure that both "Take from application" and "Minimize to jobsize" are enabled. Then, ensure that your job actually fits onto a page that'll fit on the Trotec bed. Watch for stragglers, points of vectors, errant pastes or lines. Check the Print Preview and CorelDRAW's Preflight tab. Move your work to another part of the page. If all else fails, return to the Trotec Engraver printer settings and manually set the jobsize to equal the Trotec bed size.
+When printing, venture into the Trotec Engraver printer settings, under the "Preferences" button and ensure that both "Take from application" and "Minimize to jobsize" are enabled. If these options are not showing, enable them under the "General" tab and change the view to "Expert".  Then, ensure that your job actually fits onto a page that'll fit on the Trotec bed. Watch for stragglers, points of vectors, errant pastes or lines. Check the Print Preview and CorelDRAW's Preflight tab. Move your work to another part of the page. If all else fails, return to the Trotec Engraver printer settings and manually set the jobsize to equal the Trotec bed size.
 ======Job appears to print successfully, but doesn't show in JobControl's queue======