248
edits
CNC router, wood (Precix) ID:153: Difference between revisions
Jump to navigation
Jump to search
m
CNC router, wood (Precix) ID:153 (view source)
Revision as of 09:32, 13 August 2023
, 13 August 2023→Troubleshooting
Nick.boers (talk | contribs) |
|||
| Line 140: | Line 140: | ||
Your account is not authorized/enabled to use this machine, have you taken the training? Did you pay for, attend on time and pass/participate in the training? Were you vetted at the time that you took your training? Did the instructor mark you as Attended? Please [https://my.protospace.ca/training verify your training records on Spaceport] and check in on the forums to update your account. | Your account is not authorized/enabled to use this machine, have you taken the training? Did you pay for, attend on time and pass/participate in the training? Were you vetted at the time that you took your training? Did the instructor mark you as Attended? Please [https://my.protospace.ca/training verify your training records on Spaceport] and check in on the forums to update your account. | ||
'''"ESS did not respond to wakeup message" Dialog box appears when starting Mach3.''' | ====== '''"ESS did not respond to wakeup message" Dialog box appears when starting Mach3.''' ====== | ||
This usually means the large black controller box for the machine is turned off, or did not have enough time to start before starting Mach3. | This usually means the large black controller box for the machine is turned off, or did not have enough time to start before starting Mach3. | ||
======Spindle refuses to spin====== | ======Spindle refuses to spin====== | ||
VFD overheated/off/tripped/reset? | VFD (Variable Frequency Drive motor driver - big controller box on the floor) overheated/off/tripped/reset? Power cycle with red switch next to floor. | ||
======Mach3 errors, gantry refuses to home/move====== | ======Mach3 errors, gantry refuses to home/move====== | ||
| Line 159: | Line 158: | ||
6) Zero the Z axis using a piece of paper and ‘INCR” jog mode, or Z-PROBE. If using Z probe, first check probe speeds and distances in the probing screen. **Mach3 starts in INCH mode but the probe settings are whatever the last person left them at** Make sure you change the tool number to 99 before probing. Change the tool number to 1 or 0 after probing. | 6) Zero the Z axis using a piece of paper and ‘INCR” jog mode, or Z-PROBE. If using Z probe, first check probe speeds and distances in the probing screen. **Mach3 starts in INCH mode but the probe settings are whatever the last person left them at** Make sure you change the tool number to 99 before probing. Change the tool number to 1 or 0 after probing. | ||
'''Ethernet smoothstepper ran out of data in the middle of a move''' | ====== '''Ethernet smoothstepper ran out of data in the middle of a move''' ====== | ||
This is known to happen when messing (zooming, panning / orbiting) with the view port (3D preview). When your job is running, don't mess with it | This is known to happen when messing (zooming, panning / orbiting) with the view port (3D preview). When your job is running, don't mess with it | ||