26
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Jump to navigation
Jump to search
m
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 18:03, 25 August 2022
, 25 August 2022→DXF files are distorted when imported: added information about proper units for dxf files
Craig.pearce (talk | contribs) m (→Troubleshooting: adding a solution to distorted DXF files) |
Craig.pearce (talk | contribs) m (→DXF files are distorted when imported: added information about proper units for dxf files) |
||
| Line 145: | Line 145: | ||
The lid limit switch is located rear left side of the machine. Make sure the switch is engaged and restart. Better yet, reposition the switch so it is always depressed when the lid is closed. | The lid limit switch is located rear left side of the machine. Make sure the switch is engaged and restart. Better yet, reposition the switch so it is always depressed when the lid is closed. | ||
====== DXF files are distorted when imported ====== | ======DXF files are distorted when imported====== | ||
Select/highlight the entire file in Lasercut, click Ctrl-Z. | Select/highlight the entire file in Lasercut, click Ctrl-Z. | ||
LaserCut software assumes 1 unit of your DXF file is 1 mm. Best practice is to export your drawing from your CAD file to DXF in mm. Other units (px, inches, au etc) will be ignored. Helpful tip - add a 1 inch by 1 inch square box to your original drawing. Once imported to LaserCut, scale the box (right click on box line) so the box is 24.5mm by 24.5mm. | |||
==Maintenance== | ==Maintenance== | ||