344
edits
Pat.spencer (talk | contribs) (→Setup Instructions:: Change heading format) |
Pat.spencer (talk | contribs) (→Storage Instructions:: change heading formating) |
||
| Line 71: | Line 71: | ||
These instructions are just the reverse of the deployment instructions. | These instructions are just the reverse of the deployment instructions. | ||
Step 1: | ===Step 1: === | ||
* Disconnect all electrical components and the Flex hose. | * Disconnect all electrical components and the Flex hose. | ||
Step 2: | ===Step 2:=== | ||
* Raise all of the 4 corners onto the collapsible caster. This is done by gently lifting the corner and kicking the caster under the corner. The weight should hold it in place. | * Raise all of the 4 corners onto the collapsible caster. This is done by gently lifting the corner and kicking the caster under the corner. The weight should hold it in place. | ||
Step 3: | ===Step 3: === | ||
* Pop the wall spreader bar off the pegs and allow the walls to start to fold inwards. Note that the spreader bar is stored in a couple of hooks above the door on the outside of the front wall. | * Pop the wall spreader bar off the pegs and allow the walls to start to fold inwards. Note that the spreader bar is stored in a couple of hooks above the door on the outside of the front wall. | ||
* Gently roll the booth over to the storage location. Note that you may want to hold off latching the walls tight until it is near or at it's final location. As mentioned, it is very top heavy when fully collapsed, so as a safety measure you may want to let it roll with a wider stance. | * Gently roll the booth over to the storage location. Note that you may want to hold off latching the walls tight until it is near or at it's final location. As mentioned, it is very top heavy when fully collapsed, so as a safety measure you may want to let it roll with a wider stance. | ||
== Upgrade == | == Upgrade == | ||