351
edits
Table saw (SawStop) ID:172: Difference between revisions
Add troubleshooting instructions for tilt control
No edit summary |
(Add troubleshooting instructions for tilt control) |
||
| Line 45: | Line 45: | ||
If the riving knife is truly misaligned, follow [https://thenewbiewoodworker.com/2019/06/12/adjusting-and-aligning-the-riving-knife.html this procedure]. | If the riving knife is truly misaligned, follow [https://thenewbiewoodworker.com/2019/06/12/adjusting-and-aligning-the-riving-knife.html this procedure]. | ||
'''How to remove the side access panel''' | |||
Since the side access panel doesn't open all the way, you can just remove it by pulling out the metal pin downward. | |||
'''Tilt control is lost / loose''' | |||
The tilt control wheel can become loose or disconnected if an internal collar falls off. | |||
* Open / remove the side access panel (see above) | |||
* Find both the [[Media:Sawstop-bushing-collar.jpg|bushing and collar]] | |||
* Grab a 3 mm hex driver (yellow T-handled ones can be found near metal lathe) | |||
* Re-engage control wheel and turn all the way to 45'''°''' | |||
* Reinstall bushing and collar on shaft [[Media:Sawstop-bushing-collar-installed.jpg|like this photo]], tighten set screw | |||
==Documentation== | ==Documentation== | ||