Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions

Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)

8 bytes added , 6 July 2023

248

edits

@@ Line 131: / Line 131: @@
 Your account is not authorized/enabled to use this machine, have you taken the training? Did you pay for, attend on time and pass/participate in the training? Were you vetted at the time that you took your training? Did the instructor mark you as Attended? Please verify your training records on Spaceport and check in on the forums to update your account.
-======"Soft stop" when trying to test outline of job======
+<s>======"Soft stop" when trying to test outline of job======
 Check the job origin on the lasercut software. Button on the top that says “set stop position” (red square with blue arrow). Open dialog box and de-select 'Fixed Pos'. Then use cursor to select a new start position on display.
@@ Line 161: / Line 161: @@
 ======Rabbit hangs on Startup Screen======
-If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit).
+If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit).</s>
 <br />
 ==Maintenance==