15
edits
3D printer, resin (Anycubic Photon 5.5) ID:159: Difference between revisions
3D printer, resin (Anycubic Photon 5.5) ID:159 (view source)
Revision as of 04:19, 23 February 2023
, 23 February 2023→Your First Print: Add gloves to procedure
Parker.link (talk | contribs) (Add intro) |
Parker.link (talk | contribs) m (→Your First Print: Add gloves to procedure) |
||
| Line 18: | Line 18: | ||
Resolution/Build Size: | Resolution/Build Size: | ||
* X: 1620px (82.62mm) | *X: 1620px (82.62mm) | ||
* Y: 2560px (130.56mm) | *Y: 2560px (130.56mm) | ||
* Z: 160mm | *Z: 160mm | ||
==Manuals== | ==Manuals== | ||
| Line 43: | Line 43: | ||
##Add supports as required. | ##Add supports as required. | ||
##Save to a USB stick. | ##Save to a USB stick. | ||
#Don gloves. The resin washes off pretty well with soap, but you'll wanna wear gloves. | |||
#Clean the clear plate/resivoir that goes atop the LCD using IPA. Be careful not to puncture it with your paper towel (??). | #Clean the clear plate/resivoir that goes atop the LCD using IPA. Be careful not to puncture it with your paper towel (??). | ||
#Install the clear plate on the printer and tighten the screws. | #Install the clear plate on the printer and tighten the screws. | ||