26
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 20:34, 21 October 2022
, 21 October 2022→Troubleshooting
Craig.pearce (talk | contribs) m (→DXF files are distorted when imported: added information about proper units for dxf files) |
Craig.pearce (talk | contribs) |
||
| Line 150: | Line 150: | ||
LaserCut software assumes 1 unit of your DXF file is 1 mm. Best practice is to export your drawing from your CAD file to DXF in mm. Other units (px, inches, au etc) will be ignored. Helpful tip - add a 1 inch by 1 inch square box to your original drawing. Once imported to LaserCut, scale the box (right click on box line) so the box is 24.5mm by 24.5mm. | LaserCut software assumes 1 unit of your DXF file is 1 mm. Best practice is to export your drawing from your CAD file to DXF in mm. Other units (px, inches, au etc) will be ignored. Helpful tip - add a 1 inch by 1 inch square box to your original drawing. Once imported to LaserCut, scale the box (right click on box line) so the box is 24.5mm by 24.5mm. | ||
====== Rabbit hangs on Startup Screen ====== | |||
If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit). | |||
<br /> | |||
==Maintenance== | ==Maintenance== | ||