26
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 05:11, 25 August 2022
, 25 August 2022→Troubleshooting: adding a solution to distorted DXF files
Craig.pearce (talk | contribs) m (→Troubleshooting: adding a solution to distorted DXF files) |
|||
| Line 144: | Line 144: | ||
If the laser cutter keeps displaying this message when you start your job, it means the limit switch that detects if the lid is closed is not being engaged. | If the laser cutter keeps displaying this message when you start your job, it means the limit switch that detects if the lid is closed is not being engaged. | ||
The lid limit switch is located rear left side of the machine. Make sure the switch is engaged and restart. Better yet, reposition the switch so it is always depressed when the lid is closed. | The lid limit switch is located rear left side of the machine. Make sure the switch is engaged and restart. Better yet, reposition the switch so it is always depressed when the lid is closed. | ||
====== DXF files are distorted when imported ====== | |||
Select/highlight the entire file in Lasercut, click Ctrl-Z. | |||
==Maintenance== | ==Maintenance== | ||