CNC router, wood (Precix) ID:153: Difference between revisions

CNC router, wood (Precix) ID:153 (view source)

40 bytes added , 4 February 2023

→‎Machine Overview: Added measurements from training slides

1

edit

@@ Line 107: / Line 107: @@
 '''Hold down method''': Screws, nails, clamps(must make these). Vacuum table in the future.
-Note that the hold-down table has a grid of threaded T-Nuts that can/should be used to hold down your material. If you wish to make your own sacrificial / holding system, simply prepare to fasten it down to this grid pattern.   The spacing of the threaded nuts is 4.861"  (123.63mm) on both the X and also Y axis.  Wtf is that spacing?  Why not a nice round English or Metric spacing?   Well, that is the spacing of the T-channels in the underlying bed.  Get used to it and make your templates.
+Note that the hold-down table has a grid of threaded T-Nuts that can/should be used to hold down your material. If you wish to make your own sacrificial / holding system, simply prepare to fasten it down to this grid pattern.   The spacing of the threaded nuts is 4.861"  (123.63mm) on both the X and also Y axis. (Or training slide says X:122.8 Y 123.6) Wtf is that spacing?  Why not a nice round English or Metric spacing?   Well, that is the spacing of the T-channels in the underlying bed.  Get used to it and make your templates.
 [[File:153-Precix-bed-Nuts-spacing.jpg|150x150px|Precix Mounting Nut Spacing]]