Air compressor, 80-gallon (Ingersoll Rand T30): Difference between revisions
Ian Oliver (talk | contribs) m (completed removal: updated category:compressed air tools to category:compressed air tools (removed)) |
Ian Oliver (talk | contribs) m (Ian Oliver moved page Air compressor (Ingersoll Rand T30) to Air compressor, 80-gallon (Ingersoll Rand T30): adding capacity for harmonization) |
Revision as of 11:30, 23 December 2015
This article is about a tool that is no longer at Protospace. Further information can be found below. |
- Type: Two-stage reciprocating compressor
- Make/Model: Ingersoll-Rand T30 242ON5
- Serial Number: 30T 758634
- Original Owner: Kyle Paavola
- Removed by: Kyle Paavola
- Removal Reason: ended membership
- Loan Status: Long Term Loan
- Arrival Date:
- Removal Date: 2015-12-02
- Replacements: {{{replacements}}}
- Location: Right of the welding bench
- Functional Status: Working
- Usage Permissions: Members and friends only
- Certification: To be determined. Do not start if you don't feel qualified
- Wiki-ID: [[{{{id}}}]]
Specs
This compressor is an industrial grade machine to be treated with some degree of respect. This 5HP compressor is electrically driven by 208V single phase available through the same pigtail that powers the TIG welder.
This compressor is capable of substantially higher pressure than most air tools can tolerate, which is why its discharge pressure is regulated to 100 psi. Do not adjust this regulator without consulting with Kyle. Doing so may damage your equipment or hurt you seriously.
Use and Maintenance
verbatim from the sticker right on the compressor but just in case you have not read it:
CAUTION: TURN OFF POWER BEFORE SERVICING
Daily:
- Drain any condensate from ceceiver and traps
- Check for any unusual noise or vibration
Weekly
- Check for proper oil level
Monthly
- Clean air filter
- Clean all external parts of compressor and driver
- Test relief valve manually for proper operation
- Inspect entire air system for leaks
- Inspect oil for contamination and change if necessary
- Check belt tension and wear
Every 3 months:
- Change oil using an approved lubricant
- Inspect valve assemblies
for more information, check the operator's manual at: http://manualarchive.ingersollrandproducts.com/ir_pdfs/Compressed%20Air/Air%20Compressors/Reciprocating%20Compressor/22607402.PDF
Approved Lubricant
ONLY Ingersoll-Rand All season oil is currently approved for use in this compressor. You must check for the presence of oil in the compressor pan before operating this machine.