Laser Vacuum Table: Difference between revisions
Jump to navigation
Jump to search
(Created page with "{{subst:Template:ProjectStorage}}") |
(Seeded Page) |
||
| Line 1: | Line 1: | ||
[[File:Laser_Vac_01.jpg|350px|thumb|right|]] | |||
==Info== | ==Info== | ||
'''Member name:''' | '''Member name:''' Matt F | ||
''' | '''Member contact:''' Email, found via list. | ||
''' | '''Project name & pitch:''' This is a small vacuum table for the laser, to belong to Protospace, so that you can cut paper/fabric without it blowing away from the laser's air nozzle. | ||
''' | '''Storage location:''' Bay ?? or cart | ||
'''Project start date:''' 31 Aug, 2013 | |||
'''Final Deadline:''' | '''Final Deadline:''' 01 Nov, 2013 | ||
==Updates== | ==Updates== | ||
*''' | *''' 02 Sept, 2013 -''' Vacuum is strapped to frame, box prototype is done. Vacuum is too loud. Considering running directly off of HVAC instead for low pressure air source. | ||
[[Category:OngoingProjects]] | [[Category:OngoingProjects]] | ||
Revision as of 16:24, 2 September 2013
Info
Member name: Matt F
Member contact: Email, found via list.
Project name & pitch: This is a small vacuum table for the laser, to belong to Protospace, so that you can cut paper/fabric without it blowing away from the laser's air nozzle.
Storage location: Bay ?? or cart
Project start date: 31 Aug, 2013
Final Deadline: 01 Nov, 2013
Updates
- 02 Sept, 2013 - Vacuum is strapped to frame, box prototype is done. Vacuum is too loud. Considering running directly off of HVAC instead for low pressure air source.