Laser Vent Cleaning: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 18: | Line 18: | ||
#Draw an alignment Sharpie line (optional), unscrew the vent cover and brush it clean:[[File:Laser-vent-cleaning-3.png|none|thumb]] | #Draw an alignment Sharpie line (optional), unscrew the vent cover and brush it clean:[[File:Laser-vent-cleaning-3.png|none|thumb]] | ||
#Screw the cover back on and go back down. | #Screw the cover back on and go back down. | ||
#Update this page or post on the forums that the laser vent was cleaned. | #Update this page or [https://forum.protospace.ca/t/laser-exhaust-vent-cleaned-today/9431 post on the forums] that the laser vent was cleaned. | ||
Revision as of 23:57, 5 April 2025
The laser vent on the roof should be cleaned every ~6 months. This page documents how.
Previous Cleanings
- 2025-04-05
- 2024-09-24
- ???
- 2022-04-02
Cleaning Instructions
- Grab a Philips screwdriver, a sharpie (optional), and a wire brush from the red cabinet in the welding area.
- Go up with a spotter. Take sunglasses since the white roof is very bright.
- Jam the red Featherlite ladder under the roof access ladder outside:
- Climb onto the roof. Navigate west to the lower roof and locate the laser vent:
- Draw an alignment Sharpie line (optional), unscrew the vent cover and brush it clean:
- Screw the cover back on and go back down.
- Update this page or post on the forums that the laser vent was cleaned.
