CNC router, wood (Precix) ID:153: Difference between revisions

CNC router, wood (Precix) ID:153 (view source)

19 bytes removed , 6 July

51

edits

@@ Line 253: / Line 253: @@
 Well, don't do that. Something about the probe screen/script being lame and leaving the machine in the wrong units, from step 6 in quick start above:
-) Zero the Z axis using a piece of paper and ‘INCR” jog mode, or Z-PROBE. If using Z probe, first check probe speeds and distances in the probing screen. **Mach3 starts in INCH mode but the probe settings are whatever the last person left them at** Make sure you change the tool number to 99 before probing. Change the tool number to 1 or 0 after probing.
+) Zero the Z axis using a piece of paper and ‘INCR” jog mode, or Z-PROBE. If using Z probe, first check probe speeds and distances in the probing screen.
 ===== Ethernet SmoothStepper ran out of data in the middle of a move =====
@@ Line 283: / Line 283: @@
 * Improperly tuned acceleration or velocity settings that cause slippage on an axis
 * Power was removed from the motor drivers, and the axes drifted or moved from their set position
+===== Spindle won't reach all the way down to the table =====
+Someone removed the 6 screws that hold the spindle motor plate to the Z axis and raised it 2 inches. Move it back down.
 ===== You can help expand this list by hopefully not breaking the Precix too badly! =====