CNC router, wood (Precix) ID:153: Difference between revisions

Jump to navigation Jump to search

CNC router, wood (Precix) ID:153 (view source)

Revision as of 17:33, 5 September 2021

246 bytes removed ,  5 September 2021
no edit summary
No edit summary
No edit summary
Line 56: Line 56:


Going though the machine it was found that the X and Y motors were both burned out and had to be replaced. The encoders on all axis were replaced and the motor drivers were also all replaced. The controller computer, and interface cards were also replaced at this time due to poor/wanting/or no documentation on parts or interfaces.  
Going though the machine it was found that the X and Y motors were both burned out and had to be replaced. The encoders on all axis were replaced and the motor drivers were also all replaced. The controller computer, and interface cards were also replaced at this time due to poor/wanting/or no documentation on parts or interfaces.  
 
[[File:Motion system breakdown.png|left|thumb|722x722px|Motion system breakdown]]
On May 8th 2021 the CNC made it's first official project, a 4' x 5' art piece that is hanging somewhere in Protospace (can you find it?).  
On May 8th 2021 the CNC made it's first official project, a 4' x 5' art piece that is hanging somewhere in Protospace (can you find it?).  


Line 63: Line 63:
Motion config (As of Aug 29/21) is as follows   
Motion config (As of Aug 29/21) is as follows   


Mach3 --->Smoothstep board--->C25XP board--->Gecko G320X motor drivers--->DC servo motors---↓---->~1:60 two stage planetary (on X and Y, direct on Z to ball screw)---->pinion gear


<nowiki>-----------------------------------------------------------------------------------------</nowiki>↑----AMT103V encoders set to 512 PPR


The first training session has yet to be held at the date of writing (06.01.2021)
The first training session has yet to be held at the date of writing (06.01.2021)
<br />
<br />
Retrieved from "https://wiki.protospace.ca/Special:MobileDiff/4972"

Navigation menu