89
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Jump to navigation
Jump to search
m
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 06:44, 22 November 2015
, 22 November 2015Added "The Laser Cutter" Video.
(Updated model link to Rabbit Laser's new specifications page (closest model).) |
m (Added "The Laser Cutter" Video.) |
||
| Line 1: | Line 1: | ||
{{#evt: | |||
service=youtube | |||
|id=https://www.youtube.com/watch?v=29YLiiapFHc | |||
|alignment=right | |||
}} | |||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
|toolname=Laser Cutter | |toolname=Laser Cutter | ||
| Line 10: | Line 16: | ||
|permission=Members & Friends Only | |permission=Members & Friends Only | ||
|certification=Must complete [[Laser Certification]] | |certification=Must complete [[Laser Certification]] | ||
|itemphoto= | |itemphoto=[[File:Laser cutter, open.jpg|350px|thumb|right|]] | ||
}} | }} | ||
| Line 18: | Line 24: | ||
[[Category:Textileworking tools]] | [[Category:Textileworking tools]] | ||
[[Category:Computer-controlled tools]] | [[Category:Computer-controlled tools]] | ||
==Specs== | ==Specs== | ||
| Line 32: | Line 39: | ||
* Perform a simple [[Chlorine Test]] on unapproved materials, as cutting or etching chlorinated materials damages the optics | * Perform a simple [[Chlorine Test]] on unapproved materials, as cutting or etching chlorinated materials damages the optics | ||
* See [[Power Levels]] page for notes and details on cutting and etching various materials | * See [[Power Levels]] page for notes and details on cutting and etching various materials | ||
* Power modulation | * Power modulation is in a restricted range in the software due to a firmware bug (Approximately 8%-30% represents 0%-100% power) | ||
* Controller occasionally locks up after large cut jobs. E-stop immediately if job timer does not increment in first 5 seconds of job. Post to list for recovery instructions | * Controller occasionally locks up after large cut jobs. E-stop immediately if job timer does not increment in first 5 seconds of job. Post to list for recovery instructions | ||
* Consult our [[Laser Standard Operating Procedure]] | * Consult our [[Laser Standard Operating Procedure]] | ||