3D printer, resin (ELEGOO Saturn) ID:170

From Protospace Wiki
Revision as of 06:15, 5 March 2023 by Gregm (talk | contribs) (→‎Usage)
Jump to navigation Jump to search

← Back to tools we have

170.jpg
Type ELEGOO Saturn Resin 3D Printer
Make/Model ELEGOO Saturn
Serial number ??
Original owner ??
Loan status ??
Arrival date ??
Location 3D Printer Village
Functional status Functional
Usage permissions None
Certification None
Wiki-ID [[]]
Label 1.0" 1.5" 2.0"

https://www.elegoo.com/en-ca/products/elegoo-saturn-4k-mono-lcd-3d-printer

Specs

  • System: EL3D-3.0.1
  • Operation: 3.5 Inch Touch Screen
  • Slicer Software: Chitu DLP Slicer
  • Connectivity: USB
  • Technology: LCD UV Photocuring
  • Lightsource: UV Integrated LED lights (wavelenth 405nm)
  • XY Resolution: 0.05mm(3840*2400)
  • Z Axis Accuracy: 0.00125mm
  • Layer Thickness: 0.01-0.15mm
  • Printing Speed: 30-40mm/h
  • Power Requirements: 110-240V 50/60Hz 24V4A 96W
  • Printer Dimensions: 11.02in (L) * 9.44in (W) * 17.55in (H) 28cm(L) *24cm (W) * 44.6cm (H)
  • Build Volume: 7.55in (L) * 4.72in (W) * 7.87in (H) 192mm (L) * 120mm(W) * 200mm (H)
  • Weight: 22 Lbs (10 Kg)

Usage

The leveling card should be near the machine and contains basic build platform leveling instructions.

I was told that ChiTu Box is bad at supports, and to do them in PrusaSlicer (you'll need to find/use/make a resin printer profile) then export your unsliced but supported model as STL for slicing in ChiTu Box.

Below is the usage guide, but can basically be summarized as:

  • BE CAREFUL not to damage the 4k LCD screen or FEP plastic film!
  • level the build platform
  • turn on / heat up cabinet, close doors!
  • fill tank with resin choice/color/amount
  • software, do your supports/slicing
  • cabinet warmed up now?
  • insert stick, hit go, leave for a while, check in occasionally for obvious fails
  • the build platform won't fit in the Curing station (Anycubic Wash and Cure Machine) ID:160
  • so remove your prints without damaging the build platform and toss them into the basket, see video ^
  • pour unused resin back into bottle - the tank holding stand is good for this
  • clean out any remnants from the tank, being careful not to damage the FEP plastic film
  • CLEAN UP AFTER YOURSELF
  • Think you're done cleaning? THINK AGAIN!!


Saturn1.JPG Saturn2.JPG Saturn3.JPG Saturn4.JPG Saturn5.JPG Saturn6.JPG Saturn7.JPG Saturn8.JPG Saturn9.JPG

Troubleshooting

TBD