Bandsaw, metal, horizontal (Craftex B013N): Difference between revisions

Bandsaw, metal, horizontal (Craftex B013N) (view source)

Revision as of 14:56, 19 December 2012

724 bytes added , 19 December 2012

Seeded page

Matt

Bureaucrats, Administrators

430

edits

@@ Line 1: / Line 1: @@
 {{Template:EquipmentPage
-|toolname=Band Saw (Horizontal)
+|toolname=Horizontal Metalcutting Bandsaw
-|model=Crafted B013N
+|model=Craftex B013N
 |serial=??
 |owner=Jim Akeson
-|loanstatus=Loan to Space
+|loanstatus=On Loan
-|arrived=Dec 2012
+|arrived=18Dec2012
-|location=Metalworking Shop
+|location=Metalworking Shop/Welding
 |status=Working
-|permission=Open to Members & Friends
+|permission=Open to Members, must fix/replace if you break it
-|certification=??
+|certification=Demo/Read Notes
-|itemphoto=[[File:BandSawHorizontal.jpg|350px|thumb|right|]]
+|itemphoto=[[File:Bandsaw_Horizontal.jpg|350px|thumb|right|]]
 }}
-==Notes==
+[[File:Bandsaw_Horizontal_2.jpg|350px|thumb|right|]]
-* You Break it, You Fix it
+==Specs==
-==Specs==
+* Capacity: At 90 degree 4" x 6" rectangular 4 1/2" round
-Capacity: At 90 degree 4" x 6" rectangular 4 1/2" round
+* Speed: 80,120,200 FPM
+* Gearbox: Sealed worm gear
+* Motor: 1/3 HP, 110V, 1 phase belt drive, sealed worm gear transmission
+* Table: 8" x 8 3/4" for vertical use
+* Ball bearing drive wheels and blade guides
+* Auto shut off
+* Blade size 1/2" x .025" x 64 1/2"
+* Gross weight: 50kg.
+* Carton size: 15" x 13" x 41 1/2"
-Speed: 80,120,200 FPM
+==Usage Notes==
-Gearbox: Sealed worm gear
+* Can be used as both gravity-fed bandsaw or as an upright
+* If used as upright, can attach cutting deck, 2 Phillips screws
-Motor: 1/3 HP, 110V, 1 phase belt drive, sealed worm gear transmission
+* Do not apply pressure when cutting flat, gravity is proper cutting weight
+* 3-stepped pulleys to vary speed/torque
-Table: 8" x 8 3/4" for vertical use
+* Check blade tension before each use and that blade is seated in contact with bearings properly, that bearings are clean
+* If blade comes off, power down and unplug, unscrew door knob, slide bottom plate on door up or it will snap off. Loosen tension via top knob, place blade back onto wheel grooves, re-tighten, close door and replace knob.
-Ball bearing drive wheels and blade guides
+* Sweep or blow debris off after each use
-Auto shut off
-Blade size 1/2" x .025" x 64 1/2"
-Gross weight: 50kg.
-Carton size: 15" x 13" x 41 1/2"