248
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 18:24, 6 July 2023
, 6 July 2023→History: controller upgrade
(→History: controller upgrade) |
|||
| Line 165: | Line 165: | ||
<br /> | |||
If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit).</s> | If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit).</s> | ||
| Line 298: | Line 299: | ||
*2022-02-06 | *2022-02-06 | ||
**Tumblers from locks removed from front panel. They can now be turned by hand, making it easier to remove and replace the front panel during cleaning and servicing. | **Tumblers from locks removed from front panel. They can now be turned by hand, making it easier to remove and replace the front panel during cleaning and servicing. | ||
*2023-06-01 | |||
**Controller upgrade - Leetro removed, Ruida RDC6442S installed | |||
**Software upgrade - LightBurn v1.4.0 purchased and installed, machine/device/software configured, a 'user default' process somewhat put into place | |||
**Door switch replaced and relocated - the back left corner had a weird voltage drop across the wire, and the switch itself was very crusty. This setup didn't work reliably with the Ruida, so to ensure safe operation a new switch was wired and installed in the back right corner of the lid. | |||
[[Category:Showcase tools]] | [[Category:Showcase tools]] | ||