248
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 17:58, 6 July 2023
, 6 July 2023layout
(→Troubleshooting: removed most, not applicable to Ruida) |
(layout) |
||
| Line 23: | Line 23: | ||
Arguably the most popular tool at Protospace, the '''laser cutter''' uses a CO<sub>2</sub> laser to cut and engrave a variety of non-metal materials (though some metals can be engraved). | Arguably the most popular tool at Protospace, the '''laser cutter''' uses a CO<sub>2</sub> laser to cut and engrave a variety of non-metal materials (though some metals can be engraved). | ||
<br /> | <br /> | ||
===Software=== | ===Software=== | ||
With the recent controller upgrade, this tool now uses LightBurn V1.4.00 which can be downloaded and purchased here: https://lightburnsoftware.com/pages/trial-version-try-before-you-buy | With the recent controller upgrade, this tool now uses LightBurn V1.4.00 which can be downloaded and purchased here: https://lightburnsoftware.com/pages/trial-version-try-before-you-buy | ||
| Line 162: | Line 161: | ||
======Rabbit hangs on Startup Screen====== | ======Rabbit hangs on Startup Screen====== | ||
If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit).</s> | If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit).</s> | ||