248
edits
3D printer, resin (ELEGOO Saturn) ID:170: Difference between revisions
3D printer, resin (ELEGOO Saturn) ID:170 (view source)
Revision as of 06:15, 5 March 2023
, 5 March 2023→Usage
(→Documentation: usage pics) |
(→Usage) |
||
| Line 35: | Line 35: | ||
==Usage== | ==Usage== | ||
The leveling card should be near the machine and contains basic build platform leveling instructions. | |||
I was told that ChiTu Box is bad at supports, and to do them in PrusaSlicer (you'll need to find/use/make a resin printer profile) then export your unsliced but supported model as STL for slicing in ChiTu Box. | |||
Below is the usage guide, but can basically be summarized as: | |||
* BE CAREFUL not to damage the 4k LCD screen or FEP plastic film! | |||
* level the build platform | |||
* turn on / heat up cabinet, close doors! | |||
* fill tank with resin choice/color/amount | |||
* software, do your supports/slicing | |||
* cabinet warmed up now? | |||
* insert stick, hit go, leave for a while, check in occasionally for obvious fails | |||
* the build platform won't fit in the [[Curing station (Anycubic Wash and Cure Machine) ID:160]] | |||
* so remove your prints without damaging the build platform and toss them into the basket, see video ^ | |||
* pour unused resin back into bottle - the tank holding stand is good for this | |||
* clean out any remnants from the tank, being careful not to damage the FEP plastic film | |||
* CLEAN UP AFTER YOURSELF | |||
* Think you're done cleaning? THINK AGAIN!! | |||
[[File:Saturn1.JPG]] | [[File:Saturn1.JPG]] | ||
[[File:Saturn2.JPG]] | [[File:Saturn2.JPG]] | ||
| Line 46: | Line 67: | ||
==Troubleshooting== | ==Troubleshooting== | ||
TBD | TBD | ||