Lathe, metal (Challenger 1660G) ID:46: Difference between revisions

→‎Power Feed: warrrning
(→‎Power Feed: embed video text unbreakage 2)
(→‎Power Feed: warrrning)
Line 58: Line 58:


===Power Feed===
===Power Feed===
From https://forum.protospace.ca/t/can-t-get-lathe-power-feed-to-work/3568/8:<blockquote>Set it to a lowish speed like 400 or less and bump the jog button. Then start wiggling leavers while it’s coasting down and watch the drive shaft and screw. You’ll feel it when it engages and the shafts will start spinning…
Note that while generally <u>gears/speeds shouldn't be changed while the lathe is in motion</u>, from https://forum.protospace.ca/t/can-t-get-lathe-power-feed-to-work/3568/8<blockquote>Set it to a lowish speed like 400 or less and bump the jog button. Then start wiggling leavers while it’s coasting down and watch the drive shaft and screw. You’ll feel it when it engages and the shafts will start spinning…


The threading lead screw and the power feed drive shaft are taken off at different points in the gear train. It is possible to jiggle a leaver and get one to start spinning while the other is still not engaged properly and requires further jiggling.
The threading lead screw and the power feed drive shaft are taken off at different points in the gear train. It is possible to jiggle a leaver and get one to start spinning while the other is still not engaged properly and requires further jiggling.
248

edits