248
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 01:23, 22 January 2023
, 22 January 2023→Troubleshooting
| Line 145: | Line 145: | ||
"Immediate mode" checkbox is enabled | "Immediate mode" checkbox is enabled | ||
====== | ======Arrow keys on keypad don't move laser head====== | ||
Press the Z-axis button to exit Z-axis up/down mode | Press the Z-axis button to exit Z-axis up/down mode and/or try mashing ESC | ||
======Laser head only moves a little bit each time an arrow key is pressed====== | |||
Press menu, find jog set, make it 0. | |||
======PAUSED PRESS START TO CONTINUE====== | ======PAUSED PRESS START TO CONTINUE====== | ||
If the laser cutter keeps displaying this message when you start your job, it means the limit switch that detects if the lid is closed is not being engaged. | If the laser cutter keeps displaying this message when you start your job, it means the limit switch that detects if the lid is closed is not being engaged. | ||
| Line 160: | Line 162: | ||
If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit). | If the lid is open when starting the Rabbit, it sometimes won't come out of the startup screen. Close the lid and try turning the laser off and on again. If that doesn't work, check to make sure the lid is engaging the switch when closed (the switch is in the back left side of the opening, on the body of the Rabbit). | ||
<br /> | |||
==Maintenance== | ==Maintenance== | ||