Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions

=== Monthly Checklist ===

# Clean inner and outer surfaces of laser cutter including window.  

#* Use dilute Zep Fast 505 industrial degreaser or other cleaner on hard surfaces

#* Use windex on window

#* Avoid contaminating linear rails or optics

# Wipe linear rails clean with solvent degreaser. Do not move gantry or bearings onto cleaned section of rail until all solvent evaporated to prevent contamination of bearing grease

# Grease three linear bearings using grease located in the left side compartment

#* '''DO NOT USE ANY AEROSOL OR SPRAY LUBRICANT'''

#* '''TODO: fill in make/model/type of grease'''

# Check condition of optics clean if necessary

# Check laser alignment. Adjust if necessary.

# Check bed level. Adjust if necessary.

# Check tension on all belts. Adjust if necessary.

# Check tension on all belts. Adjust if necessary.

# Inspect electronic components for operation including six limit switches (±X, ±Y, ±Z axis), lights and light wiring, electronics cooling fan

# Blow out dust from chiller radiator

=== As Required ===

* Inspect Z-bed screws for smooth operation. Clean and regrease if required. Z screws must be thoroughly cleaned with solvent degreaser before re-applying clean grease.

* Replace worn or failed laser optics including mirror or lens. Check alignment after any optics replacement.

* Thoroughly clean smoke and residue off internal surfaces of laser cutter

** Use concentrated Zep Fast 505 industrial degreaser

** Avoid contaminating linear rails or optics

Shocks replaced on lid