Sandblasting cabinet, floor, blue (Powerfist) ID:130: Difference between revisions

update manual links, formatting
(pasted from mailing list, better than nada)
(update manual links, formatting)
Line 13: Line 13:
}}
}}


Model/Parts: https://www.princessauto.com/en/detail/floor-model-abrasive-blasting-cabinet/A-p8046492e
[[:File:8046492 manualhb 00 01 v01 manuel enfr.pdf|Manual]]


Manual: https://images11.palcdn.com/hlr-system/Documents/80/804/8046/8046492_manualhb_00_01_v01_manuel_enfr.pdf
[[:File:8046492 partshb 00 01 v01 pieces enfr.pdf|Parts]]
 
Parts: https://images11.palcdn.com/hlr-system/Documents/80/804/8046/8046492_partshb_00_01_v01_pieces_enfr.pdf




The shopvac, tornado and hoses likely need attention. Has been neglected since moved from under the racking and plasma table showed up.
The shopvac, tornado and hoses likely need attention. Has been neglected since moved from under the racking and plasma table showed up.


Window is 12x24" clear <3mm acrylic, if you can't see your workpiece cut a new one. There should be a stack of three under the black plastic bezel:


* top outside which gets sandy from the air
* middle which has the LEDs
* and the bottom sacrificial which should really have plastic tearaway sheets but never looked hard enough for them. This could/should be glass? Special invincible glass?? Air curtain!??


Window is 12x24" clear <3mm acrylic, if you can't see your workpiece cut a new one. There should be a stack of three under that black plastic bezel: top outside which gets sandy from the air, middle which has the LEDs, and the bottom sacrificial which should really have plastic tearaway sheets but never looked hard enough for them. This could/should be glass?


The sticker on the front says 100psi max but the manual says 125, depends how soft/dirty your workpiece is. You'll want to sift the media before you start, sift the media when the gun clogs often, maybe sift the media for the next user too. There should be an empty bucket for releasing the trapdoor into, a small beat up metal strainer to slowly dump the bucket back into the unit thru, and a bag of media but you really do not need to add.
The sticker on the front says 100psi max but the manual says 125, depends how soft/dirty your workpiece is. You'll want to sift the media before you start, sift the media when the gun clogs often, maybe sift the media for the next user too. There should be an empty bucket for releasing the trapdoor into, a small beat up metal strainer to slowly dump the bucket back into the unit thru, and a bag of media but you really do not need to add.
248

edits