296
edits
MiniCNCBasics: Difference between revisions
m
cosmetic
Aerobatpat (talk | contribs) m (Added comments on the position of the Spindle switch and speed control.) |
Aerobatpat (talk | contribs) m (cosmetic) |
||
| Line 24: | Line 24: | ||
5. Clear any error messages in Status | 5. Clear any error messages in Status | ||
The first thing is to | |||
The first thing is to notice the Red flashing border on the Reset button and Status message. | |||
The example shows: “Limit Switch Triggered”. And the scrolling message says “Press Reset… Emergency mode Active. Emergency Z Inhibit”. | The example shows: “Limit Switch Triggered”. And the scrolling message says “Press Reset… Emergency mode Active. Emergency Z Inhibit”. | ||
<br>[[File:141-Reset-Button-Error-State.jpg]] | <br>[[File:141-Reset-Button-Error-State.jpg]] | ||