Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions

Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)

372 bytes removed , 11 September 2020

49

edits

@@ Line 81: / Line 81: @@
 ==Repairs Needed==
-*Upgrades discussed
+Shocks replaced on lid
-**Adding air cooling to optics and laser head block
-**Convincing power supply to modulate power levels properly
-**Seal display on controller to prevent smoke from clouding over time.
-**Replace and upgrade chiller (current chiller struggles to keep up with heat generated, and has no safeties on it to signal failure)
-**Relocate chiller to an open-air position (wall mounted)
 ==Repair History==