296
edits
MiniCNCBasics: Difference between revisions
m
→Step 5 – Loading and editing your G-Code
Aerobatpat (talk | contribs) |
Aerobatpat (talk | contribs) |
||
| Line 99: | Line 99: | ||
Notice that the line highlighted in the G-Code dialog box is also highlighted in the tool path window. | Notice that the line highlighted in the G-Code dialog box is also highlighted in the tool path window. | ||
Important Note: in the sample, on line 2, it says to go to Z-26. This was what I entered before I understood how to use the height sensor properly. This is using a reference of Z as Zero after using the buck to sense the height, but then I incorrectly reset the Z height to zero manually. <br> | <b>Important Note:</b> in the sample, on line 2, it says to go to Z-26 (G1 Z-26 F150). This was what I entered before I understood how to use the height sensor properly. This is using a reference of Z as Zero after using the buck to sense the height, but then I incorrectly reset the Z height to zero manually. <br> | ||
This will be updated with a proper graphic and instructions once we figure it out. <br> | This will be updated with a proper graphic and instructions once we figure it out. <br> | ||
Meanwhile, set your code to a very small number and test it first before you break a bit. | Meanwhile, set your code to a very small number (G1 Z-0.5 F150) and test it first before you break a bit. | ||
<br>[[File:141-Tool-Path-View-1.jpg]] | <br>[[File:141-Tool-Path-View-1.jpg]] | ||