80 watt laser engraver: Difference between revisions

added laser setup and shut down procedure
No edit summary
(added laser setup and shut down procedure)
Line 35: Line 35:


6mm  speed ?    power ?
6mm  speed ?    power ?
----


Importance of focusing/lens choice
Importance of focusing/lens choice
http://www.thefabricator.com/article/lasercutting/the-importance-of-focal-positions-in-laser-cutting
http://www.thefabricator.com/article/lasercutting/the-importance-of-focal-positions-in-laser-cutting
Focus on the surface, under the surface, or on the bottom surface.
Focus on the surface, under the surface, or on the bottom surface.
== Powering up the machine ==
With very few exceptions, the same order of operations should always be maintained for safe proper operation:
1. Open cutting area and remove any objects from the working bed.
2. Plug in circulation pump to a 110v circuit. (currently does not power on with chiller),
3. Power on 120-240 voltage converter (box on trolley with green light-up switch)
--Verify that power is applied to the chiller and air pump.  These are 220v appliances and need to be plugged directly into the voltage converter.
4. Set up ventilation fan outdoors, leave unplugged but switch unit on.  During colder temperatures only run exhaust while cutting is taking place.
5. Activate power to laser cutter from switch on back of unit.
6. Deactivate E-stop with a twisting motion, and power on laser with key switch on front panel.
The laser is now active and ready to accept instructions from the laptop.
== Using the machine ==
regurgitate the above here
== Shutting down the machine ==
Following the same steps in reverse order will help ensure the machine is left in a safe mode.
1. Activate E-stop to render the work-area safe. 
2. Clean out remnants from the cutting area.
3. Turn off power from the key switch, this will turn off the work-light.
4. Deactivate/put away exhaust fan
5. Power down voltage converter (green switch)
6. Unplug circulation pump
7. Turn off power to back of unit
17

edits