4
edits
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6: Difference between revisions
Laser cutter, large (Rabbit Laser RL-80-1290) ID:6 (view source)
Revision as of 20:00, 20 September 2014
, 20 September 2014no edit summary
No edit summary |
No edit summary |
||
| Line 23: | Line 23: | ||
==Usage Notes== | ==Usage Notes== | ||
* Complete [[Laser Certification]] to learn how to use the laser. Training is offered about once a month. | * Complete [[Laser Certification]] to learn how to use the laser. Training is offered about once a month. | ||
* Perform a simple [[Chlorine Test]] on unapproved materials, as cutting or etching chlorinated materials damages the optics | * Perform a simple [[Chlorine Test]] on unapproved materials, as cutting or etching chlorinated materials damages the optics | ||
| Line 29: | Line 28: | ||
* Power modulation only in restricted range in software (Aproximately 8%-30%) | * Power modulation only in restricted range in software (Aproximately 8%-30%) | ||
* Controller occasionally locks up after large cut jobs. E-stop immediately if job timer does not increment in first 5 seconds of job. Post to list for recovery instructions | * Controller occasionally locks up after large cut jobs. E-stop immediately if job timer does not increment in first 5 seconds of job. Post to list for recovery instructions | ||
* Consult our [[Laser Standard Operating Procedure]] | |||
==History== | ==History== | ||