Bending brake, 30" (Powerfist)
| This article is about a tool that is no longer at Protospace. Further information can be found below. |
- Type: 30" Benchtop Metal Bending Brake
- Make/Model: Powerfist SKU 8008201
- Serial Number: N/A
- Original Owner: Matt F
- Removed by: {{{removedby}}}
- Removal Reason: {{{removalreason}}}
- Loan Status: Short Term Loan
- Arrival Date: 12Mar2013
- Removal Date: {{{removaldate}}}
- Replacements: Brake, box and pan, 24"
- Location: Metalworking Shop
- Functional Status: Working
- Usage Permissions: Ask owner before use.
- Certification: None
- Wiki-ID: [[{{{id}}}]]
Specs
- 30" brake
- Handles up to 17g steel (about 1/16"). Will handle more but requires heavier clamping
- Bends up to 90 degrees
Usage Notes
- Clamp or bolt brake to worktable
- Flatten brake, line up workpiece sheet
- Lay bracing steel above workpiece
- Clamp bracing steel to workpiece and brake using c-clamps (two on edges minimum, extras if possible).
- Insert levers into holes
- Bend smoothly upwards
- Depending on springiness of workpiece, some overbend is necessary. Bracing steel is cut farther than 90 degrees to account for springback on 90 degree bends.
- Lower brake, check angle, disassemble clamps.
- For pieces with internal bends, use scrap steel cut to proper width. Do not cut up original bracing steel.