Drill press, 8" (Jobmate) ID:69
 | |
| Type | Drill Press |
| Make/Model | Jobmate 8" |
| Serial number | ?? |
| Original owner | Thomas L |
| Loan status | Long term loan |
| Arrival date | Fall 2010 |
| Location | Woodworking Shop |
| Functional status | Working |
| Usage permissions | Open to Members & Friends |
| Certification | Self-Taught |
| Wiki-ID | 69 |
| Label | 1.0" 1.5" 2.0" |
Usage Notes
- There are 3 belt settings, ensure the belt setting is correct for the material
- Adjust bit with chuck key, then return chuck key to its holder
- Twist chuck by hand to ensure bit is centered, not stuck between two jaws
- Adjust table height/position by loosening rear left bolt, then lifting the table manually (twisting left and right helps)
- Ensure table hole is lined up with bit. If not, bit will drill through table and ruin it (note existing "extra" hole)
- Tighten rear-left bolt to secure table
- Ensure workpiece is secured
Specs
- Jobmate Bench Drill Press, 8-in
- Adjustable depth stop for accurate measurement. Tilting table with clamping slots. Column to chuck is 4" (10.16cm). 1/2" keyed chuck