3D printer, resin (ELEGOO Saturn) ID:170: Difference between revisions

← Older edit

3D printer, resin (ELEGOO Saturn) ID:170 (view source)

Revision as of 14:05, 5 March 2023

1,278 bytes added , 5 March 2023

Update owner/status

Gregm

273

edits

@@ Line 3: / Line 3: @@
 | model = ELEGOO Saturn
 | serial = ??
-| owner = ??
+| owner = Brian Queen
-| loanstatus = ??
+| loanstatus = Donated!
-| arrived = ??
+| arrived = December 2022
 | location = 3D Printer Village
 | status = Functional
@@ Line 35: / Line 35: @@
 ==Usage==
+The leveling card should be near the machine and contains basic build platform leveling instructions.
+I was told that ChiTu Box is bad at supports, and to do them in PrusaSlicer (you'll need to find/use/make a resin printer profile) then export your unsliced but supported model as STL for slicing in ChiTu Box.
+Below is the official usage guide, and you may want to [[3D printer, resin (Anycubic Photon 5.5) ID:159#Usage|refer to the similar usage steps for our other resin printer]], but can basically be summarized as:
+*BE CAREFUL not to damage the 4k LCD screen or FEP plastic film!
+*level the build platform
+*turn on / heat up cabinet, close doors!
+*fill tank with resin choice/color/amount
+*software, do your supports/slicing
+*cabinet warmed up now?
+*insert stick, hit go, leave for a while, check in occasionally for obvious fails
+*the build platform won't fit in the [[Curing station (Anycubic Wash and Cure Machine) ID:160]]
+*so remove your prints without damaging the build platform and toss them into the basket, see video ^
+*pour unused resin back into bottle - the tank holding stand is good for this
+*clean out any remnants from the tank, being careful not to damage the FEP plastic film
+*CLEAN UP AFTER YOURSELF
+*Think you're done cleaning? THINK AGAIN!!
 [[File:Saturn1.JPG]]
 [[File:Saturn2.JPG]]
@@ Line 46: / Line 67: @@
 ==Troubleshooting==
-TBD
-==Documentation==
 TBD