Drill press, 8" (Jobmate) ID:69: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
m (updated image link) |
||
| (7 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
{{ | {{Equipment page | ||
|toolname=Drill Press | | toolname = Drill Press | ||
|model=Jobmate 8" | | model = Jobmate 8" | ||
|serial=?? | | serial = ?? | ||
|owner=Thomas L | | owner = Thomas L | ||
|loanstatus=Long term loan | | loanstatus = Long term loan | ||
|arrived=Fall 2010 | | arrived = Fall 2010 | ||
|location=Woodworking Shop | | location = Woodworking Shop | ||
|status=Working | | status = Working | ||
|permission=Open to Members & Friends | | permission = Open to Members & Friends | ||
|certification=Self-Taught | | certification = Self-Taught | ||
|itemphoto=[[File: | | id = 69 | ||
| itemphoto = [[File:69.jpg|350px|thumb|right|]] | |||
}} | }} | ||
[[Category:Plasticworking tools]] | |||
[[Category:Woodworking tools]] | |||
[[Category:Machine tools]] | |||
==Usage Notes== | ==Usage Notes== | ||
* There are 3 belt settings, ensure the belt setting is correct for the material | |||
* Adjust bit with chuck key, then return chuck key to its holder | * Adjust bit with chuck key, then return chuck key to its holder | ||
* Twist chuck by hand to ensure bit is centered, not stuck between two jaws | * Twist chuck by hand to ensure bit is centered, not stuck between two jaws | ||
| Line 24: | Line 30: | ||
==Specs== | ==Specs== | ||
* | * Jobmate Bench Drill Press, 8-in | ||
* Adjustable depth stop for accurate measurement. Tilting table with clamping slots. Column to chuck is 4" (10.16cm). 1/2" keyed chuck | |||
Latest revision as of 07:04, 8 January 2017
 | |
| Type | Drill Press |
| Make/Model | Jobmate 8" |
| Serial number | ?? |
| Original owner | Thomas L |
| Loan status | Long term loan |
| Arrival date | Fall 2010 |
| Location | Woodworking Shop |
| Functional status | Working |
| Usage permissions | Open to Members & Friends |
| Certification | Self-Taught |
| Wiki-ID | 69 |
| Label | 1.0" 1.5" 2.0" |
Usage Notes
- There are 3 belt settings, ensure the belt setting is correct for the material
- Adjust bit with chuck key, then return chuck key to its holder
- Twist chuck by hand to ensure bit is centered, not stuck between two jaws
- Adjust table height/position by loosening rear left bolt, then lifting the table manually (twisting left and right helps)
- Ensure table hole is lined up with bit. If not, bit will drill through table and ruin it (note existing "extra" hole)
- Tighten rear-left bolt to secure table
- Ensure workpiece is secured
Specs
- Jobmate Bench Drill Press, 8-in
- Adjustable depth stop for accurate measurement. Tilting table with clamping slots. Column to chuck is 4" (10.16cm). 1/2" keyed chuck