Plasma cutter, huge (Powercut 1500) ID:51: Difference between revisions
Jump to navigation
Jump to search
m (Removed notes about White Compressor) |
Ian Oliver (talk | contribs) (added category Category:Metalworking tools) |
||
| Line 12: | Line 12: | ||
|itemphoto=[[File:Plasma_Cutter_Yellow.jpg|350px|thumb|right|]] | |itemphoto=[[File:Plasma_Cutter_Yellow.jpg|350px|thumb|right|]] | ||
}} | }} | ||
[[Category:Metalworking tools]] | |||
==Usage Notes== | ==Usage Notes== | ||
Revision as of 09:06, 14 October 2014
| [[File:{{{id}}}.jpg|250px]] | |
| Type | Plasma Cutter |
| Make/Model | Powercut 1500 |
| Serial number | ?? |
| Original owner | William |
| Loan status | Donated to Protospace |
| Arrival date | July 2012 |
| Location | Welding/Metalworking Shop |
| Functional status | Near Functional (read Repair Notes) |
| Usage permissions | Open to Members & Friends |
| Certification | Must be certified |
| Wiki-ID | [[{{{id}}}]] |
| Label | 1.0" 1.5" 2.0" |
Usage Notes
- Cuts metal via plasma arc
- Eye protection must be worn at all times, (welding helmet or oxy/ace goggles suffice)
- Leather gloves/sleeves required
- Place workpiece on a raised surface, do not cut flush against floor or workbench
- Attach grounding clamp, ensure good contact (no paint)
- Set cutting power & air pressure according to workpiece thickness
- NEVER cut without air supply at sufficient pressure, requires airflow for cooling
- DO NOT make contact with tip to workplace, this melts the tip.
- Tips gradually wear out, are consumable.
Specs
- 3ph input
- 20-90A output
- Requires high volume compressed air supply