View source for Brake, shear, roller, 52" (Magnum) ID:152

{{Equipment page removed
| removedby     = John W
| toolname      = Metal brake/shear/roller
| model         = Magnum 52"
| serial        = 
| owner         = John W
| loanstatus    = Returned
| arrived       = TBC
| location      = Returned to owner
| removaldate   = 2023
| removalreason = Returned to owner
| replacements  = TBD
| status        = Ok
| permission    = Members
| certification = See Usage Notes
| id            = 152
| formerid      = [[41]], [[142]]
| caption       = Please take a photo and upload it!
| photo         = NoImage.png
}}

==Exit Update==
https://forum.protospace.ca/t/metal-sheer-in-need-of-a-tune-up/4040/11

"The combo sheet metal machine has indeed left Protospace and gone to its forever home."

==Usage Notes==

From the mailing list:

It is not an aluminum bender, it is a sheet metal machine that can bend, roll and cut sheet metal (mild steel or aluminum). It can handle mild steel up to 18 gauge, and although it does not have a spec for aluminum sheet, I would guess that it would be fine to about 14 gauge with aluminum. It should not be used to cut stainless steel over about 20 gauge, but bending or rolling should be fine on even slightly thicker material as long as you are not putting too much force on the machine.

NEVER cut or bend any sort of wire with it. It can be used to roll rod and wire up to about 3/8" in diameter.

Don't cut, bend or roll your fingers or any other body extremities  - you will not be happy with the result. If you are doing something with this machine and it starts to hurt, stop doing it immediately to avoid any injuries. Be careful, the edges of cut sheets can be very sharp.

==Manuals==

Manual for this actual machine, very little useful information beyond a parts diagram: [[:File:Magnum_Shear_Brake_Slip_Roll_Owners_Manual.pdf]]

Manual for a similar but smaller machine that actually covers use: [[:File:t21320_m.pdf]]

{{DEFAULTSORT:Brake,_shear,_roller,_52"_(Magnum)_ID:142}}